Integra DTR-7.2 Setup menus, Navigating through the Setup menu, Button on remote controller

Setup menus

When making the various settings required to configure your DTR-7.2 optimally, you can either use the OSD menu that appears on your television monitor or you can use the display on the front of the DTR-7.2. The OSD menu is a settings menu that is displayed on your TV monitor. For use as reference when performing the setting procedures, this manual shows both the OSD menu displayed on your television monitor and the display on the front of the DTR-7.2.

The Setup menu consists of a main screen that is divided up into 5 menus: Hardware Setup, Speaker Setup, Input Setup, Audio Adjust, and Preference. These menus are then divided up into various sub-menus, and these contain settings for you to optimize your home theater as you wish.

Advanced Menu

0.Hardware Setup 1.Speaker Setup 2.Input Setup 3.Audio Adjust 4.Preference

→Basic Menu

ENTERQuit:SETUP

Main menu

1.Speaker Setup

1.Speaker Config 2.Speaker Distance 3.Level Calibration 4.Bass Peak Level

ENTERQuit:SETUP

Menu

1-1.Speaker Config

a.Subwoofer :Yes

b.Front :Small

c.Center :Small

d.Surr L/R :Small e.Surr Back :Small f.Surr Back Out :1ch

Quit:SETUP

Sub-menu

Navigating through the Setup menu

You can change settings using the buttons on the front panel and on the remote controller.

The buttons on the remote controller correspond to those on the DTR-7.2 as shown below.

Button on remote controller	Button on DTR-7.2
SETUP	Setup
	Setup
(upper edge of	UP
ENTER button)
(lower edge of	DOWN
ENTER button)
(left edge of	LEFT
ENTER button)
(right edge of	RIGHT
ENTER button)

1.Press the SETUP button.

The main menu screen of the Main menu appears on your TV monitor.

2.Using the and cursor buttons, select the menu that you want to enter.

3.Press the ENTER button to enter the selected menu.

The screen for that menu appears.

4.Using the and cursor buttons, select the sub- menu that you want to enter, and press the ENTER button.

Each sub-menu has different settings that can be changed as desired, and they are all explained below. To change a setting, first select it using the and cursor buttons, and then change the setting using the and cursor buttons.

5.Press the RETURN button to set the new settings and return to the previous menu screen, and again to return to the main screen.

Note:

Press the SETUP button to exit the Setup menu immediately.

	Enter
ENTER	Enter
	Return
RETURN	Return

27