Flash Memory Programming
2.Change your computer’s BIOS setting so that your system boots from the
3.Use the RAID Software Suite
a.Boot the computer with the bootable RAID Software Suite
b.At the
c.The Flash Recovery Utility detects any IIR controllers that are in reset mode and lists them in the order that they are found.
Note: Any IIR controllers that are not in reset mode will not be listed. If no controllers are listed, your controller may not be in reset mode. Shut down the system and start again with step 1 above. Refer to Figure
d.Type a controller number to start the recovery process for the firmware on that controller. You do not need to press Enter after typing the number. You will see the messages shown below during a successful recovery. Each message provides a percent complete status while the action is in progress. The entire process may take several minutes.
Erasing flash memory Downloading data to flash memory Verifying flash content with input file Flash upload complete
SUCCESS: Operation completed successfully Download complete in <duration of flash recovery>
4.Reset the jumper to run mode.
a.Power off all system components and disconnect power cords.
b.Remove the system cover.
c.Remove the IIR controller from your system.
d.On Jumper block J1B1 move jumper from position
e.Replace the cover, reconnect all power cords and power up the system.
5.Change your computer’s system BIOS setting so that your system boots normally (not from the
Note: A firmware recovery returns the controller to the default settings.
Hardware Installation and User’s Guide | 25 |
