Intel 273561-003 manual Installing the IIR Controller, IIR Controller Component Layout

Hardware Installation

Figure 2-1. IIR Controller Component Layout

	167mm (6.57 inches)
		I/O Processor
DS2A1
		SDRAM

56mm (2.20 inches)

J1B1

Flash Memory

64Bit PCI Interface

(Requires a RAIDIOS-enabled PCI slot)

2.2.2Installing the IIR Controller

1.Power-off the computer system.

2.Disconnect power cord(s) and remove the system cover.

3.Install the IIR controller into an available RAIDIOS-enabled PCI slot. See Figure 2-2.

Note: The computer system (with RAIDIOS-enabled PCI slot) illustrated in Figure 2-2may not be representative of your system. Consult your system docs for the exact location of the RAIDIOS-enabled PCI slot.

4.Connect one end of the SCSI cable to the on-board SCSI connector. Connect the other end of the SCSI cable to the SCSI drives or drive enclosure.

Note: Ensure that the end of the SCSI bus is properly terminated. See Section 2.4 in this guide for termination details.

5. Replace the system cover and reconnect power cord(s).

14 Hardware Installation and User’s Guide