Intel 510T manual Installing and Managing, Switches

C H A P T E R 2 Intel Device View

	Installing and Managing
	Switches
Following installation of	After installing Intel Device View, you can add new switches, estab-
Intel Device View	lish or expand stacks of switches, and manage existing switches and
	stacks.
Adding new switches	To add new switches (that have not been assigned an IP address) to
	Intel Device View, select Device>Install. The Install Wizard
	will start and guide you through the installation.
The Install Wizard	The Install Wizard requires that you enter a minimum amount of in-
	formation to set up the switch for management by Intel Device View.
	To select the correct new device, you need to know the device’s MAC
	address. You can find this on a label on the rear panel of the device.
	You must assign an IP address (and subnet mask) to the switch on
	your Local Area Network (LAN).

Intel Device View uses this address for configuration and manage- ment purposes.

26