User’s Manual
2.2.2.10 Boot Up NumLock Status
Sets the boot up Num Lock status. The options are “On” and “Off”.
| Item | Description |
| On | Enable NumLock |
| Off | Disable NumLock |
2.2.2.11 Gate A20 Option | ||
| Item | Description |
| Normal | A pin in the keyboard controller controls GateA20 |
| Fast | Lets chipset control GateA20 (Default) |
2.2.2.12 Typematic Rate Setting
The typematic rate is the rate key strokes repeat as determined by the keyboard controller.
The commands are “Enabled” or “Disabled”. Enabling allows the typematic rate and delay to be selected.
2.2.2.13 Typematic Rate (Chars/Sec)
The BIOS accepts the following input values (characters/second) for typematic rate: 6, 8, 10, 12, 15, 20, 24, and 30.
2.2.2.14 Typematic Rate (Msec)
Typematic delay is the time interval between the appearances of two consecutive characters, when the key is continuously depressed. The input values for this category are: 250, 500, 750, and 1000 (ms).
2.2.2.15 Security Option
This category determines whether the password is required when the sys- tem boots up or
only when entering setup. The options are:
Item |
| Description |
|
|
|
System | The system will not boot and access to Setup will be denied if the |
|
|
| |
correct password is not entered at the prompt. |
|
|
| ||
|
|
|
| ||
Setup | The system will boot, but access to Setup will be denied if the correct |
|
|
| |
password is not entered at the prompt. |
|
|
| ||
|
|
|
| ||
|
|
|
|
| |
|
| To disable security, select PASSWORD SETTING at Main Menu and | |||
|
| then you will be asked to enter password. Do not type anything and | |||
|
| just press <Enter>, it will disable security. Once the security is | |||
|
| disabled, the system will boot and you can enter Setup freely. |
| ||
|
| ATX Main board 63 | |||
