Hardware Installations and Upgrades
Installing the Front Bezel
Use the steps below if your system includes either the standard front bezel or the front bezel for the Intel Local Control Panel. The front bezel is optional.
1.At each end of the bezel, line up the center notch on the bezel with the center guide on the rack handles.
2.Push the bezel onto the front of the chassis until it clicks into place.
3.Lock the bezel.
4.Connect any necessary cables to the front control panel area at the right side of the chassis.
TP01595
Figure 12. Installing the Front Bezel
Removing and Installing the Processor Air Duct
Always operate your server chassis with the processor air duct in place. The air duct is required for proper airflow to maintain proper cooling of the processors.
For instructions on adding or replacing a processor, first remove the processor air duct, and then see your server board user guide for instructions on processor installations and removals. Return to these instructions to reinstall the processor air duct after installing your processor and heat sink.
28
