Intel Server RAID Controller U3-1 Hardware Setup

Hardware Requirements•Server with CD-ROM Drive (not attached to Intel Server RAID Controller U3-1)•One available PCI slot (64 bit, 33 MHz recommended)•Monitor display resolution of 800 x 600 or higher (recommended)•Intel Server RAID Controller U3-1 Adapter Card•PCI 2.2 Compliant System BIOS•Memory: SDRAM DIMM ECC unless already installed. See supported parts athttp:// support.intel.com/support/motherboards/server/srcu31Installing Intel Server RAID Controller U3-1 into a System

The SRCU31 comes with the Intel Integrated RAID firmware already programmed into the flash memory. Note that you must install an approved SDRAM ECC DIMM into the memory socket prior to SRCU31 installation. Refer to the approved memory list at

http://support.intel.com/support/motherboards/server/srcu31

WARNING

SHOCK HAZARDS may be present inside the unit in which this card is being installed. Disconnect all power cords to the unit before removal of any covers.

Follow the warnings noted in your computers user or service manual before installing this board. ONLY after all the covers are reinstalled should you reattach the power cords and power up the unit for the software installation and use.

1Power down the system, disconnect power cord(s) and remove the system cover.

2Install the SRCU31 into an available PCI slot. Connect one end of the SCSI cable to the internal (68 pin) or external (VHDCI) SCSI connector on the SRCU31. Connect the other end of the SCSI cable to the SCSI drives or drive enclosure.

3Replace the system cover, reconnect power cord(s).✏NOTE

SRCU31 will work in a 32 bit slot, however, a 64 bit, 33 MHz PCI slot is recommended. Consult the system guide for the target server board to determine an appropriate 64 bit, 33 MHz PCI slot.

✏NOTE

Ensure that the end of the SCSI bus is properly terminated. Consult the documentation for the drives or drive enclosure for termination details.

Intel Server RAID Controller U3-1 (SRCU31)

7

Quick Start Guide