Intel Integrated RAID Setup Splash Screen

b.Click on the Setup button. See the figure above. The RAID Software Suite setup program starts.

c.Complete the installation using the default selections

Windows 2000 (only): A “Digital Signature Not Found” message box may pop up during the installation. If this occurs, click “Yes” to continue the installation.

d.When setup is complete a message will pop up indicating that a reboot is necessary and give a choice to “reboot now” or “reboot later”.

e.Remove the CD-ROM from the CD ROM drive and select “reboot now”. The system MUST be rebooted immediately after installation of the RAID Software Suite.

f.Windows 2000 (only): After the system reboots a message will pop up indicating that a new device has been found and that the “I2Odisk.sys” driver has been started. This is the device driver for the RAID volume itself. The message will prompt for a reboot. Reboot the system to complete the installation.

✏NOTE

Refer to the user’s manual for information on HP Openview and RAID Monitor, SNMP, DMI components or remote storage console. Also see the user’s manual for instructions on customizing your RAID volumes using Storage Console.

Intel Server RAID Controller U3-1 (SRCU31)

11

Quick Start Guide