Kenmore 790.4672 manual Self-Cleaningcontd, Display, When the Self-CleanCycle is Completed

Self-Cleaning (cont'd)

What to Expect during Cleaning

While the oven is in operation, the oven heats to temperatures much higher than those used in normal cooking. Sounds of metal expansion and contraction are normal. Odor is also normal as the food soil is being removed. Smoke may appear through the oven vent. If heavy spillovers are not wiped up before cleaning, they may flame and cause more smoke and odor than usual. This is normal and safe and should not cause alarm. If available, use an exhaust fan during the self-cleaning cycle.

The cooktop lockout I_1feature will be activated during the self-clean and will unlock after the oven has cooled down.

Self-Clean Cycle Time Length

The FLEX CLEAN @ pad controls the Self-Cleaning feature. If you are planning to use the oven directly after a self-clean cycle remember to allow time for the oven to cool down and the oven door to unlock. This normally takes about one hour. So a 3 hour self- clean cycle will actually take about 4 hours to complete.

*It is recommended to use a 2 hour self-clean cycle for light soils, a 3 hour cycle for average soils, and a 4 hour cycle for heavy soils (to assure satisfactory results).

INSTRUCTIONSPRESS

To set the controls for a 3 hour Self-Cleaning cycle to start immediately and shut off automatically

1.Be sure the clock is set with the correct time of day and the oven door is closed.

2. Press	_.	"CLEAN"		will flash and	"3:00" HR will show in the			@
display (Figure 1). The control will automatically clean for a 3
hour period (default self-cleaning cycle time). Note: If a 2 or 4
hour	clean	time	is desired, press (_		@	@	for 2 hour or
press	_'_	_	_	for a 4 hour clean		time. Set the cleaning
	v

time based on the amount of soil: light, medium or heavy (* See above).

3. Press The "DOOR LOCKED" icon will flash; "CLEAN", START

I_1icon and the letters "CLn" will remain on in the display (Figure 2).

4.As soon as the control is set, the motor driven oven door lock will begin to close automatically. Once the door has been locked the "DOOR LOCKED" indicator light will stop flashing and remain on.

Also, the oven icon will appear in the display (Figure 3).

Note: Allow about 15 seconds for the oven door lock to close.

To avoid

possible burns use care when opening the oven door after the Self-Cleaning cycle. Stand to the side of the oven when opening the door to allow hot air or steam to escape.

DO NOT force

the oven door open. This can damage the automatic door locking system. Use caution and avoid possible burns when opening the door after the Self-Cleaning cycle has

completed. The oven may still be VERY HOT.

DISPLAY

Figure 1

Figure 2

Figure 3

When the Self-Clean Cycle is Completed

1."Hot" will appear in the display to indicate the oven must cooled down before it can be used normally (Figure 4).

2.Once the oven has cooled down enough "Hot" message will disappear, the oven door will unlock and "DOOR LOCKED" will disappear from the display. The oven door can then be opened (Figure 5).

Stopping or Interrupting a Self-Cleaning Cycle

If it becomes necessary to stop or interrupt a self-cleaning cycle due to excessive smoke or fire in the oven:

1. Press @. @

2.The oven door can only be opened after the oven has cooled down for approximately 1 HOUR and "Hot" and "DOOR

LOCKED" icon are no longer displayed (Figure 5). 38

Figure 4

Figure 5