Kenmore 790.4672 manual General Care & Cleaning contd, Changing the Oven Light, To Remove, Halogen

General Care & Cleaning (cont'd)

Removing and Replacing Warmer (Warm & Ready TM) Drawer

	in serious injury	or death. Turn the power off at the main	Left Glide
_I_	source before cleaning and servicing the warmer drawer.
	I _	Electrical Shock Hazard can occur and result
To Remove	Warmer Drawer:

Pull up lever with finger

1. _	Turn the power off at the main source before
removing	the warmer drawer.

2.Open the drawer to the fully opened position.

3.Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever (See Figure 1).

4.Pull the drawer away from the range.

To Replace Warmer (Warm & Ready TM) Drawer:

1.Pull the plastic slider to the front of the glide slots on each side of the drawer cavity (See Figure 2).

2.Align the glide on each side of the drawer with the drawer cavity glide slot.

3.Push the drawer into the drawer cavity until glide levers "click"

(approximately 2"). If you do not hear the glide levers "click" or the drawer does not feel seated remove the

drawer and repeat steps 1 thru 3.

Note: The Warmer Drawer will NOT operate while in the "Self-Clean"and "Oven Lockout" modes

Pull down lever
with finger	Right Glide
Figure	1

Figure 2

Changing the Oven Light

The oven lights will automatically turn ON when the oven door is opened. The

oven lights may also be manually operated by pressing the @ pad.

The oven light bulb is covered with a glass shield. The glass shield can be

removed to be cleaned manually orto change oven light. THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.

To replace the light bulb:

CAUTION: BE SURE THE OVEN IS COOL.

1. _ Turn the power off at the main source.

2.Wear a leather-faced glove for protection against possible broken glass.

3.To remove the glass shield, lift up on side with gloved finger and use force to pull shield out.

4.Replace halogen light appliance bulb taking care not to touch the bulb with your bare fingers. Touching bulb with your skin can leave a film on the bulb that causes it to burn out quickly.

5.Replace glass shield in opposite order and manner of removal.

Lift	backside
of glass shield
and	remove it.	Halogen

Light Bulb

44