Kenmore 790.4672 manual Setting Surface Controls ¢ontd, Operating Single Radiant Surface Elements

Setting Surface Controls (¢ont'd)

Operating Single Radiant Surface Elements

The cooktop has 4 SINGLE radiant surface elements: the RIGHT REAR position (Figure 1), the CENTER REAR position (Figure 2) and the LEFT FRONT and REAR positions (Figure 3).

To Operate the Single Radiant Surface Elements:

1.Place correctly sized cookware on the radiant surface element.

2,	Touch	and hold	the	pad for the desired element position until a beep	is heard.
	The display will show " -- ". Note: If no further pads are touched within 10 seconds
	the request to power the element ON will clear.
3.	Touch	HI _	pad once	to turn ON the power level to HI. Touch Lo	pad

once for Lo (See Figure 4).

4. Each touch of the HI _ or Lo _ pad will increase or decrease power levels

from 9.5 through 3.0 by .5 increments. Simmer power levels between 3.0 and 1.2 will decrease or increase by .2 increments. Lo is the lowest power level available.

Note: The power level may be adjusted at any time while the element is ON.

5. When cooking has been completed touch the pad once to turn the element

OFF. Each surface element provides a constant amount of heat at each setting. A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area. Note: The Hot Surface indicator light will remain ON if the cooktop is still hot and will remain ON until the heating surface area has cooled sufficiently.

Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.

Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the surface elements.

Figure 1

Right Rear Element

Figure 2

Center Rear Element

Figure 3

Left Frontand Rear Elements

Figure 4

10