Setting Surface Controls (cont'd)
Operating the Bridge Surface Element
The cooktop is equipped with a "BRIDGE" surface element located at the left cooktop position (See Figure 1). Indicator lights on the control panel are used to indicate what portions of the Bridge element will heat. The Bridge element begins with the left FRONT position only (Figure 2) and when selected with the +BRIDGE element (Figure 3) it will provide a combination of 2 heating surfaces. When set for ALL the left rear element is added for a total combination of 3 even heating surfaces (See Figure 4).
The Bridge element is designed for rectangular or oval shaped cookware. The griddle that is supplied with this appliance should be used with the Bridge element ONLY. For round shaped cookware, the left front and left rear elements may be used as a single element.
|
| ALLo_ |
|
|
| +BRIDGE o |
|
|
| FRONT_ | • |
Figure | 1 | Figure 2 | |
ALLo | I | ALL_ | I |
+BRIDGE O |
| +BRIDGE _ |
|
FRONTO | • | FRONTO | • |
To Operate | the Bridge Surface | Element: | Figure 3 | Figure 4 |
|
|
1.Place correctly sized cookware on the radiant surface element.
2. | Touch and hold the | pad for the Bridge element position until a |
beep is heard. The display will show " - - ". Note: If no further pads are touched within 10 seconds the request to power the element ON will clear.
3.Select the FRONT (See Figure 2), +BRIDGE (See Figure 3) or ALL 3
|
|
|
|
| ELEM_ |
|
| |
| elements (See Figure | 4) to heat by pressing the _ | pad once, | twice or | ||||
| three | times (Figures 4 & 5 shows indicator lights | with | ALL 3 elements | ||||
| selected). |
|
|
|
|
|
| |
4. | Touch | HI _ | pad once to turn ON the power | level to HI. Touch | Lo | |||
| ||||||||
| (_pad |
| once for Lo (See Figure 5). The Hot Surface | indicator | light | |||
| will turn ON when the element becomes hot. |
|
|
|
| |||
6. Each | touch | of the HI _ | or Lo _'_ pad will increase | or decrease | ||||
|
|
|
| v |
|
|
|
|
power levels from 9.5 through 3.0 by .5 increments. Simmer power levels between 3.0 and 1.2 will decrease or increase by .2 increments. Lo is the lowest power level available. Note: The power level may be adjusted at any time while the element is ON.
7. | When | cooking | has been completed touch the | pad once to turn the |
| entire | element | OFF. |
|
Hi
( V Lo
Figure 5
Each surface element provides a constant amount of heat at each setting. A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area. If no element size is chosen when the Bridge element is turned ON, the control will default to the left front element only. See page 9 for recommended surface cooking settings.
Note: If you bridge all three elements, any previous power level setting for the LEFT REAR element will be changed to the power level setting for the Bridge.
Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.
Do not place aluminum foil or plastic items such as salt and pepper shakers, spoon holders or
plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or
wooden spoons could catch fire if placed too close to the surface elements.
12