Basic Operations

When “ON” is set:

3 - 3 - 1 . Touch [ ] key to enter detail setting stage.

3 - 3 - 2 . Slide along [ ] slider or touch [ ]/[ ] key to select the value in sequence of

HIGHMIDLOW

The factory default setting is “MID”.

3 - 4 . After completing settings, touch the [ENT] key to return to the 1st selected item.

Adjusting the balance 3 - 1 . Select “BALANCE”.

3 - 2 . Touch [] key to enter detail setting stage.

3 - 3 . Slide along [ ] slider or touch [ ]/[ ] key to adjust the balance of the right and left speakers.

The factory default setting is “CENTER”.

(Adjustment range: RIGHT 12 to LEFT 12)

3 - 4 . After completing settings, touch the [ENT] key to return to the 1st selected item.

Adjusting the fader 3 - 1 . Select “FADER”.

3 - 2 . Touch [] key to enter detail setting stage.

3 - 3 . Slide along [ ] slider or touch [ ]/[ ] key to adjust the balance of the rear and front speakers.

The factory default setting is “CENTER”.

(Adjustment range: FRONT 12 to REAR 12)

3 - 4 . After completing settings, touch the [ENT] key to return to the 1st selected item.

Adjusting the M-BEX

3 - 1 . Select M-BEX”.

3 - 2 . Touch [] key to enter detail setting stage.

3 - 3 . Slide along [ ] slider or touch [ ]/[ ] key to turn on or turn off the MAGNA BASS EXTEND effect.

The factory default setting is “OFF”. (Adjustment range: ON/OFF)

3 - 4 . After completing settings, touch the [ENT] key to return to the 1st selected item.

Adjusting the high pass filter 3 - 1 . Select “HPF”.

3 - 2 . Touch [] key to enter detail setting stage.

3 - 3 . Slide along [ ] slider or touch [ ]/[ ] key to select the setting in sequence

6090120THROUGH

The factory default setting is “THROUGH”.

This is supported only with amplifiers equipped with this function. Output is not supported from RCA cables.

Setting the subwoofer

You can set the low pass filter of subwoofer.

3 - 1 . Select S-W LPF”.

3 - 2 . Touch [] key to enter detail setting stage.

3 - 3 . Slide along [ ] slider or touch [ ]/[ ] key to select the setting in sequence

THROUGH6090120

The factory default setting is “THROUGH”.

Adjusting the subwoofer output volume

You can adjust the volume output from the unit’s subwoofer output terminal.

This adjustment can be performed only when the S-W LPF” is set to “60”, “90” or “120”.

3 - 1 . Select S-W VOL”.

3 - 2 . Touch [] key to enter detail setting stage.

3 - 3 . Slide along [ ] slider or touch [ ]/[ ] key to increases or decreases the subwoofer volume.

The factory default setting is “0”. (Adjustment range: +6 to -6)

When the volume level is more than 30, the subwoofer volume adjustment value can not reach +6.

Note:

During SOUND adjustment mode, if no operation is performed for more than 10 seconds, this mode can be cancelled and return to previous mode.

English

FZ709E 15

Page 11
Image 11
Clarion FZ709E Adjusting the M-BEX, Setting the subwoofer, Adjusting the subwoofer output volume, When on is set