English

Common Operations

Setting the dimmer control

You can set the dimmer control “ON” or “OFF”.

The factory default setting is “ON”.

3 - 1 . Select “DIMMER”.

3 - 2 . Touch [ ] key to enter detail setting stage.

3 - 3 . Slide along [ ] slider or touch [ ]/[ ] key to select “ON” or “OFF”.

Anti-theft indicator

The red Anti-theft indicator is a function for pre- venting theft.

The factory default setting is “OFF”.

3 - 1 . Select “BLINKING LED”.

3 - 2 . Touch [ ] key to enter detail setting stage.

3 - 3 . Slide along [

] slider or touch [ ]/[ ]

key to select

ON” or “OFF”.

Setting the external amplifier

When an external amplifier is used, the noise can be decreased by turning off the power supply of the internal amplifier.

The factory default setting is “OFF”.

3 - 1 . Select “AMP CANCEL”.

3 - 2 . Touch [ ] key to enter detail setting stage.

3 - 3 . Slide along [

] slider or touch [ ]/[ ]

key to select

ON” or “OFF”.

ON

Use with connected AMP.

OFF

Use for inside AMP.

Accessory interrupt setting

If you connect this unit and supported accessory with a separately sold cable, you can listen the output sound on your car speakers.

The factory default setting is “OFF”.

3 - 1 . Select INT-SWITCH”.

3 - 2 . Touch [ ] key to enter detail setting stage.

3 - 3 . Slide along [

] slider or touch [ ]/[ ]

key to select

ON”, “OFF” or “MUTE”.

ON

You can listen from the speakers when accessory is connected to this unit.

When listening to the connected accessory, you can adjust the volume by turning the [ROTARY] knob.

OFF

This unit continues normal operation even when the accessory is interrupted.

MUTE

The sound from this unit is muted during accessory is interrupted.

Performing a system check

This function allows you to perform a system check from the adjust mode when required.

3 - 1 . Select “SYSTEM CHECK”.

3 - 2 . Touch [ENT] key. “SYSTEM CHECK” ap- pears in the display.

3 - 3 . After finish checking, this unit will switch to previous mode.

AUX function

This system has an external input jack on the rear panel so you can listen to sounds and music from external devices connected to this unit.

Selecting AUX IN sensitivity

Make the following settings to select the sensi- tivity when sounds from external devices con- nected to this unit are difficult to hear even after adjusting the volume.

The factory default setting is “MID”.

1.During AUX mode, touch the [] key to switch to ADJ menu.

2.Select OPTION in the menu to enter AUX OP- TION mode.

3.

Select “AUX SENSE” and touch [

] key to

 

enter detail setting stage.

 

4.

Slide along [

] slider or touch [

]/[ ] key

 

to select “HIGH”, “MID” or “LOW”.

 

Note:

When AUX mode is selected, AUX IN sensitivity can be set.

38 FZ709E

Page 34
Image 34
Clarion FZ709E owner manual AUX function