CHAPTER 3 - BIOS SETUP
The board installed is not responding to the ID request, or no board ID has been found in the indicated slot.
NOTE: When this error appears, the system will boot in ISA mode, which allows you to run the EISA Configuration Utility.
Slot not empty
Indicates that a slot designated as empty by the EISA Configuration Utility actually contains a board.
NOTE: When this error appears, the system will boot in ISA mode, which allows you to run the EISA Configuration Utility.
System halted,
Indicates the present boot attempt has been aborted and the system must be rebooted. Press and hold down the CTRL and ALT keys and press DEL.
Wrong board in slot
PLEASE RUN EISA CONFIGURATION UTILITY
The board ID does not match the ID stored in the EISA
NOTE: When this error appears, the system will boot in ISA mode, which allows you to run the EISA Configuration Utility.
Floppy disk(s) fail (80)
Unable to reset floppy subsystem.
Floppy disk(s) fail (40)
Floppy Type dismatch.
Hard disk(s) fail (80)
HDD reset failed.
Hard disk(s) fail (40)
HDD controller diagnostics failed.
Hard disk(s) fail (20)
HDD initialization error.
Hard disk(s) fail (10)
Unable to recalibrate fixed disk.
Hard disk(s) fail (08)
Sector Verify failed.
Keyboard is locked out - Unlock the key.
Unlock the key. BIOS detect the keyboard is locked. P17 of keyboard controller is pulled low.
Keyboard error or no keyboard present
Cannot initialize the keyboard. Make sure the keyboard is attached correctly and no keys are being pressed during the boot.
Manufacturing POST loop
System will repeat POST procedure infinitely while the P15 of keyboard controller is pulling low. This
SYS7180VE User’s Manual | 57 |
CHAPTER 3 - BIOS SETUP
is also used for M/B burn in test.
BIOS ROM checksum error - System halted
The checksum of ROM address
Memory test fail
BIOS reports the memory tests fail if the onboard memory is tested error.
58 | SYS7180VE User’s Manual |
