Intel SYS7180VE user manual Hardware Installations, 1.6Block Diagram, Installation procedure

CHAPTER 1 – Introduction

1.6Block Diagram

Processor	SOCKET 478	CLOCK
PWM	P4 PROCESSOR	ICS950220

CHAPTER 2 –Hardware Installations

Chapter 2 Hardware Installations

This chapter provides information on how to use the jumpers and connectors on the SYS7180VE in order to set up a workable system.

2.1	Installation procedure
2.1.1 Insert the system BIOS (if not already installed) genteelly. Pay attention to
	the position of pin 1 of BIOS socket.

VGA CRT CONNECTOR

ADDR	CTRL	DATA
	AGTL+ BUS
ADDR	CTRL	DATA

GMCH

BROOKDALE-G

FCBGA760

DDR 266 Mhz

DDR266 Modules

PICMG PCI/ISA SLOT

2.1.2 Install the processor with correct orientation.

2.1.3 Insert the DRAM module with correct orientation.

2.1.4 Mount the Fan on the top of the processor and connect it to FAN connector.

2.1.5 Insert all external cables except for flat panel. (Hard disk, floppy, keyboard,

Mouse, LAN, etc.)

2.1.6 Prepare a CRT monitor for CMOS setup.

IDE Primary

IDE Secondary

USB 2.0

PORT 1-6

FirmWare Hub

UDMA66/100

USB I/F

LPC INTERFACE

ICH4

	PCI TO ISA
	Bridge
	W83629D
	W83629D
CNTRL + PCI ADDR/DATA
	PHY
	82562EM
	GIGA LAN
PCI	CONTROLLER
	82540
	RAID IDE
	CONTROLLER
	PDC20265R

LAN 10/100 RJ45-Connector

GIGA LAN

Connector

RAID Primary IDE

RAID Secondary IDE

2.1.7	Confirm the power supply is off.
2.1.8	Turn on the power.

Note: The CMOS memory may be in an undefined state at power-on after a period of no battery backup.

LPC SUPER-I/O

W83627HF

	AC'97
AC'97 LINK
	CODEC

Audio Connector

Floppy	Keyboard	COM1	COM2	Parallel	IrDA
	Mouse	RS232	RS232 /
			422 /
			485

SYS7180VE User’s Manual 5

6 SYS7180VE User’s Manual