Intel Vig390s manual Problems and Suggestions, What happens What to do

Problems and Suggestions

Table 24: Problems and Suggestions

What happens	What to do
Application software	Try resetting the system.
problems	Make sure all cables are installed correctly.
	Verify that the system board jumpers are set properly.
	Verify that your system hardware configuration is set correctly. In
	Setup, check the values against the system settings you recorded
	previously. If an error is evident (wrong type of drive specified, for
	example), make the change in Setup and reboot the system. Record
	your change.
	Make sure the software is properly configured for the system. Refer to
	the software documentation for information.
	Try a different copy of the software to see if the problem is with the
	copy you are using.
	If other software runs correctly on the system, contact the vendor of
	the software that fails.
	If you check all of the above with no success, try clearing CMOS
	RAM and reconfiguring the system. Make sure you have your list of
	system settings available to re-enter, because clearing CMOS RAM
	sets the options to their default values.
Characters on-	Make sure the brightness and contrast controls are properly adjusted
screen are distorted	on the monitor.
or incorrect	Make sure the video signal cable and power cables are properly
	installed.
	Make sure your monitor is compatible with the video mode you have
	selected.
Characters do not	Make sure the video display is plugged in and turned on.
appear on screen	Check that the brightness and contrast controls are properly adjusted.
	Check that the video signal cable is properly installed.
	Make sure a video board is installed, enabled, and the jumpers are
	positioned correctly.
	Reboot the system.
CMOS RAM settings	If system settings stored in CMOS RAM change for no apparent
are wrong	reason (for example, the time of day develops an error), the backup
	battery may no longer have enough power to maintain the settings.
	Replace the battery (Chapter 2).
Diskette drive light	Make sure the power and signal cables for the drive are properly
does not go on when	installed.
drive is in use or is	Check that the drive is properly configured and enabled in Setup.
tested by POST

Vig390s Motherboard Manual V1.0 52