Intermec PD4 manual Printout not in desired position

Chapter 7—Troubleshooting

Printout not in desired position	Check for bad settings in the application
	or ESim command errors
	Check if label gap sensor is disturbed
	by media, dust, or erroneously loaded
	transfer ribbon
	Check lateral position of label gap sensor
	Calibrate label gap sensor in Autoadjust
	Mode
	Check the edge guide and media guides
	Check the media (too little liner transpar-
	ency, weak black marks, or interfering
	preprint at the back of the media?)
	Check if platen roller needs cleaning or
	replacement
When printing, page skipping occurs	Check if label gap sensor is disturbed by
	dust or foreign objects
Weak printout	Check density setting
	Check if thermal printhead needs cleaning
	Check printhead pressure
	Check printhead dot line position
Uneven darkness across media path	Check printhead balance
When using cutter, label was not cut	Check if media is loaded correctly
straight
When using cutter, label was not cut suc-	Check whether media thickness exceeds
cessfully	0.16 mm (6.3 mils)
	Check if media is loaded correctly
When using cutter, label could not feed or	Check if cutter is installed properly
abnormal cutting occurs	Check if paper feed rods are sticky. Clean
	if necessary using isopropyl alcohol
When using stripper, abnormal function	Check if stripper full sensor is working
occurs	Check if media is loaded properly

Note: If further problems should occur, please contact your distributor for more information.

48 Intermec EasyCoder PD4—User’s Guide