Chapter 9—Adjustments
5Turn both screws at the front of the printhead carefully clockwise a quarter of a turn at a time (a full turn corresponds to 0.5 mm which is a lot). Make sure to make identical adjustments on both the screws! If you get lost, tighten both screws by turning them counterclockwise as far as they go and start all over again.
6Engage the printhead and Lock the printhead by tightening the two screws at the top of the printhead bracket, that is, the reverse action of step #3.
7Load the ribbon (only in case of thermal transfer printing).
8Test and readjust if necessary. (Hint! If you use direct thermal media you will not have to load and remove the ribbon over and over again.)
Intermec EasyCoder | 61 |
