Intermec PD4 manual

66

Intermec EasyCoder PD4—User’s Guide

Hook

Washer

Coil spring

Post

3 Insert the hinged high edge guide into the slot in the post (see the next page).

4 First fit the washer and then the coil spring from underneath the post to the protruding part of the edge guide and engage the coil spring to the hook (see the next page).

5 The high edge guide is hinged to allow media load. Before removing an empty core or loading a roll of media, the guide must be flipped down to a horizontal attitude. Likewise, after loading the media it must be flipped back so it points straight up. Like the low edge guide, it can be adjusted along the post to fit different media widths (see the next page).

Edge guide

2

Remove the coil spring and the washer, then pull up the edge guide and save it away for possible later use.

Chapter 9—Adjustments

Switching Edge Guide

As standard, the EasyCoder PD4 is fitted with a low edge guide on the media supply roll post. The low edge guide makes it simple to fit a media supply roll on the post, but it only guides the core of the roll. Therefore, the EasyCoder PD4 is delivered with an enclosed high edge guide which the user can fit quite easily when the application so requires, for example when the printer cannot be placed on a horizontal surface or when the media roll tends to unwind itself.

To replace the edge guide, follow these steps:

1 Unhook the coil spring from the hook at the bottom of the plastic edge guide underneath the post.