Intermec PD4 manual Tickets with Black Mark, ⇒ Black Mark Width

Appendix B—Media Specifications

Tickets with Black Mark

⇐ a ⇒ Media Width

Maximum:	118.0 mm	(4.65 inches)
Minimum:	25.0 mm	(1.00 inches)

⇐ b ⇒ Copy Length

Maximum:

8 dots/mm (203.2 dpi)	1270 mm	(50 inches)
11.81 dots/mm (300 dpi)	558.8 mm	(22 inches)
Minimum:
8 dots/mm (203.2 dpi)	10 mm	(0.39) inches)
11.81 dots/mm (300 dpi)	10 mm	(0.39) inches)

⇐c ⇒ Detection Position

Variable: 0 to 57 mm (0 to 2.24 inches)

⇐d ⇒ Black Mark Width

The detectable width of the black mark should be at least 5.0 mm (0.2 inches) on either side of the LSS detection point.

⇐e ⇒ Black Mark Length

Maximum:	25 mm	(0.98 inches)
Common:	5 mm	(0.2 inches)
Minimum:	3 mm	(0.12 inches)

⇐f ⇒ Black Mark Y-Position

It is recommended that you place the black mark as close to the front edge of the ticket as possible and use a negative Stop Adjust value to control the media feed, so the tickets can be properly torn off.

Paper Type Setup

• Black mark

Note: Preprint that may interfere with the detection of the black mark should be avoided.

Note: The black mark should be non-reflective carbon black on a whitish background. Do not allow any perforations to break the edge of the media as this may cause the media to split and jam the printer.

Intermec EasyCoder PD4—User’s Guide 81