SECTION
Adjusting Footplate Height
Spring Button Height
NOTE: For this procedure, refer to FIGURE 4.2.
NOTE: This procedure applies to the swingaway front riggings and swingaway elevating legrest.
1.Remove the front rigging assembly. Refer to Installing/Removing Front Riggings on page 31.
NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure.
2.Pull the cam lock lever up to unlocked position.
NOTE: The elevating legrest has two sets of release buttons, one set above the other. Each set will be visible one at a time allowing finer footplate height adjustment.
3.Push in the release buttons and reposition the footplate assembly to the desired height.
4.Ensure that the release buttons fully protrude from holes on both sides of the front rigging support.
Front Rigging Support
Release Button
Adjustment
Footplate
Holes 
Assembly
Cam Lock Lever
5.Rotate cam lock lever down to locked position.
6.Repeat this procedure for the other footplate, if necessary.
NOTE: Swingaway footrest shown.
FIGURE 4.2 Spring Button Height
7.Reinstall the swingaway front rigging assembly. Refer to Installing/Removing Front Riggings on page 31.
Bolt-In-Place Height
NOTE: For this procedure, refer to FIGURE 4.3 on page 33.
NOTE: This procedure applies to the swingaway footrests and swingaway elevating legrest.
1.Remove the swingaway front rigging. Refer to Installing/Removing Front Riggings on page 31.
NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure.
2.Pull the cam lock lever up to the unlocked position.
3.Using a screw driver to hold the threaded rivet in position, remove the button head screw from the threaded rivet.
4.Remove the threaded rivet and button head screw securing the footplate assembly to the front rigging support.
Lightweight, Standard and Heavy Duty Wheelchairs 32 | Part No. 1114811 |
