IRIS MODEL P522 APPLICATION MANUAL
ful discrimination, it is likely due to the | 3. Check the voltage at pins 4 (26 VDC) | |
automatic gain control (AGC) action (see | and 5 (PWR GND) of the viewing | |
sections on the viewing heads for a de- | head connector. If the voltage is zero, | |
tailed explanation of this problem). | check the wiring of the connector for | |
When using the PbS only or the S506 | shorts and/or replace the viewing head | |
(same for the S512), make sure the sig- | cable. If 26 VDC is measured, then | |
nal is not saturating, particularly at | the viewing head may be defective, | |
high load conditions. (Refer to section | and should be replaced. | |
ORIFICING.) | C. FLAME SIGNAL SHOWS ON DIS- | |
| ||
C. For the S550, the S552 and the S556, see | PLAY; FLAME ON RELAY AND | |
corresponding manual(s). | LIGHT ARE OFF. | |
TROUBLESHOOTING GUIDE | 1. The viewing head is incorrectly wired, | |
A. NO FLAME SIGNAL and NO DISPLAY | or defective (see B, above). | |
| ||
1. Check wiring (refer to section WIR- | 2. The set point values for flame ON | |
are incorrect. | ||
ING AND INSTALLATION). | ||
| ||
2. Check the voltage at PWR IN termi- | D. FLAME SIGNAL SHOWS ON ANA- | |
LOG BARGRAPH DISPLAY; FLAME | ||
nals with a volt meter. It should mea- | ||
ON LIGHT IS OFF; LOCKOUT | ||
sure approximately 26 VDC. If not, | ||
LIGHT IS ON. | ||
check the power supply and wiring, | ||
| ||
or replace the power supply. | 1. The viewing head may be defective. | |
| ||
3. If 26 VDC is measured, remove the | 2. There may be a noise or ground- | |
power for 10 seconds. If the | ||
ing problem (see NOISE INTER- | ||
setting fuse has tripped, removing then | ||
FERENCE AND GROUNDING, | ||
reapplying power will reset the fuse. | ||
following section). | ||
| ||
B. DIGITAL DISPLAY IS SHOWING | 3. Press RESET button on front panel. | |
0000 AND NO FLAME SIGNAL | ||
E. | ||
1. Using a volt meter, check at viewing | ||
| ||
head A terminals, on the bottom of the | 1. There may be a noise or grounding | |
mother board, for 26 VDC across +V | problem (see D2, above). | |
and GND. If the voltage is low, check | 2. The viewing head may be defective. | |
the power supply. If the supply is okay, | ||
| ||
removing and reapplying the power af- | F. FRONT PANEL BUTTONS DO NOT | |
ter 10 seconds will reset the 0.25A self- | RESPOND. | |
resetting fuse if it has tripped. | 1. The P522 front panel may be locked out. | |
2. If the voltage measures 26 VDC at | ||
NOISE INTERFERENCE | ||
P522 terminals, remove the connector | ||
from the viewing head, and open the | AND GROUNDING | |
red connector (refer to viewing head | On the | |
|
wiring diagram of this plug, Figure 2).
at the bottom of the P522, the terminals marked GND go to pin 5 on the viewing head plug (see section WIRING OF VIEWING HEAD). Pin 5 of the view-
Page 18