Assembly
Figure 3
Step 1:
Connect hand pulse sensor
Step 2:
Locate the front (A1) and rear (A2) main frames. Connect both front and rear frames. To secure, use six bolts (N1), six spring washers (N2) and six washers (N3) - make sure all holes are lined up correctly. Note: Ensure that all wires are secure inside tube during the entire time both frames are being secured. Be careful not to pinch wires.
Figure 4
Step 1:
Locate main support tube (D) and console tube cover (I). Slide main tube cover up the main support tube.
Step 2:
Connect hand pulse sensor wire - front (A25) coming from main support tube to hand sensor wire - middle (A23) coming from the main frame.
Connect power wire (A26) coming from main support tube (D) to power wire (A21) coming from the main frame.
Step 3:
Secure main support tube to main frame (A1) using four bolts (N1) and four spring washers (N2) and two washers (N3). Slide main support tube cover down until it meets the main frame.
Figure 3
Figure 4
8
D
I
