Chapter 3 Hardware Overview
3.3 Rear Panel
The following figures show the rear panels of the AC power input model switch. The rear panel contains a connector for the power receptacle.
Figure 13 Rear Panel - AC Model
3.3.1 Power Connector
Make sure you are using the correct power source as shown on the panel.
To connect the power to the switch, insert the female end of power cord to the power receptacle on the rear panel. Connect the other end of the supplied power cord to a 100~240V AC, 1.5A power outlet.
3.4 LEDs
The following table describes the LEDs.
Table 2 LEDs
LED | COLOR | STATUS | DESCRIPTION |
PWR | Green | On | The system is turned on. |
|
|
|
|
|
| Off | The system is off. |
|
|
|
|
10/100 Mbps Ethernet Ports |
| ||
|
|
|
|
LNK/ACT | Amber | Blinking | The system is transmitting/receiving to/from a 10/100 Mbps |
|
|
| Ethernet network. |
|
|
|
|
|
| On | The link to a 10/100 Mbps Ethernet network is up. |
|
|
|
|
|
| Off | The link to an Ethernet network is down. |
|
|
|
|
FDX/COL | Amber | On | The Ethernet port is negotiating in |
|
|
|
|
|
| Blinking | The switch is detecting collisions on the Ethernet port. |
|
|
|
|
|
| Off | The Ethernet port is negotiating in |
|
|
|
|
Gigabit Ethernet Ports |
|
| |
|
|
|
|
100/1000 | Green | On | The link to a 10/1000 Mbps Ethernet network is up. |
|
|
|
|
| Amber | On | The link to a 100 Mbps Ethernet network is up. |
|
|
|
|
|
| Off | The link to an Ethernet network is down. |
|
|
|
|
ACT | Green | On | The link to an Ethernet network is up. |
|
|
|
|
|
| Blinking | The Ethernet port is transmitting/receiving data. |
|
|
|
|
|
| Off | The link to an Ethernet network is down. |
|
|
|
|
38 |
| |
| ||
|
|
|