Jackson 300XLT, 300XS, 300XN Service Procedures, Rinse Solenoid Valve Repair Parts Kit Continued

SECTION 5: SERVICE PROCEDURES

RINSE SOLENOID VALVE REPAIR PARTS KIT (CONTINUED)

Removing the valve bonnet

13.Slowly remove the valve bonnet. Note: The spring for the plunger is located directly under the bonnet and may come free if you are not careful. Remove the plunger, spring and valve bonnet and place to the side.

Removing the O-ring

14.Remove the O-ring and inspect it. If it has any tears or cuts or excessive flat spaces, it should be replaced.

15.Examine the threads for the valve bonnet. Check them for scoring or signs of damage. Take a cloth and clean them out to remove any foreign particles that might get lodged in the threads and cause a leak. Severely damage threads should not be repaired; instead it is recommended that the entire valve should be replaced. These instructions do not provide information on replacing the solenoid valve.

16.Note: Even though an O-ring may not appear damaged, it is a good idea to go ahead and replace it if you have a new one. This will help ensure that your valve remains leak-free in the future!

Removing the diaphragm

17.Remove the diaphragm retainer and then the diaphragm itself. Many problems associated with a solenoid valve can be traced to a clogged pilot port in the diaphragm.

Pointing out the extension hole

18.As indicated in the photo above, the extension hole can become clogged. If it is difficult to clean out, you can use a heated straight pin to push through the hole. The center hole, the pilot port, must also be clear. If the diaphragm is torn or bent in any way, it must be replaced.

1

2

Diaphragm showing (1) pilot port and (2) extension hole

300X Series Technical Manual 7610-002-64-22

Issued: 07-26-2006 Revised: N/A

24