SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS
DELIMING OPERATIONS
DELIMING OPERATIONS: In order to maintain the dishmachine at its optimum performance level, it will be required to remove lime and corrosion deposits on a frequent basis. A deliming solution should be available from your detergent supplier. Read and follow all instructions on the label of the deliming solution.
To proceed with the deliming operation, fill the dishmachine and add the correct amount of deliming solution as recommended by the deliming solution manufacturer. The water capacity of the various tanks of the dishmachine can be verified on the spec- ification pages of this manual.
Perform the following operations to delime the dishmachine:
1.Turn the machine on.
2.Disconnect or turn off all chemical feeder pumps.
3.Close all doors (after adding the deliming solution).
4.Run the machine for the recommended period of time.
5.Turn the unit off and open the doors.
6.Wait five minutes, then inspect the inside of the machine. If the machine is not delimed, run another time cycle as per the deliming solution’s instructions.
7.When clean, drain and
8.Run in MANUAL for 10 minutes to remove residual deliming solution.
9.Drain and
DELIMING THE ELECTRIC BOOSTER HEATER: In order to maintain the electric booster heater at its optimum performance level, it will be required to remove lime and corrosion deposits on a frequent basis. To delime, please refer to the instruction manual that came with your particular electric booster heater. A deliming solution should be available from your detergent sup- plier. Read and follow all instructions on the label of the deliming solution.
JFT Series Technical Manual
Issued:
17
