DRILLING TOP RING
OUTSID
E
15° 
IMPORTANT:
MUST DRILL AT A 15°
1/8"ANGLE TO AVOID 
DRILLING THROUGH ROLLER TRACK OF TOP RING.
11.Drill a 3/32" diameter hole into the top ring at about 15° . (See Illustration 20.) Engage the top of the fixed panel with the top ring groove. Secure the top of the fixed panel to the top ring. (See Illustration 21.)
ILLUSTRATION 20
DRILLING TOP RING
ROLLER | FIXED |
TRACK | PANEL |
TOP |
|
RING |
|
GROOVE |
|
15° | H9 |
IMPORTANT: | |
MUST DRILL AT 15° |
|
ANGLE TO AVOID |
|
DRILLING THROUGH |
|
ROLLER TRACK. |
|
ILLUSTRATION 21
RING TO BRACKET
SCREW (2) H9
WASHER (2) H5
FLAT PORTION
OF TOP RING
DRILL TWO (2) 3/32"
DIAMETER HOLES
ILLUSTRATION 22
H9 | SCREW | M3.5X9.5MM | |
STAINLESS STEEL | |||
|
12.Plumb and square the tower. Mark a point through each slot of the wall bracket. Drill two (2) 3/32" diameter holes in the top ring through the slots of the bracket. (See Illustrations 22.) Secure the top ring to the wall bracket.
LOCATED IN HARDWARE KIT
H5 | WASHER | FLAT WASHER |
#8 TYPE B | ||
| STAINLESS STEEL | |
H9 | SCREWS | M3.5X9.5MM |
STAINLESS STEEL | ||
|
|
18
