www.clearcreekspas.com
TROUBLESHOOTING GUIDE
PROBLEM | PROBABLE CAUSE | REMEDY |
5. Noisy pump and motor. | A. Clogged strainer(s). | A. Clean strainers |
| B. Leakage of air into suction line. | B. Locate and repair leaks. |
| C. Vibrating parts attached to | C. Tighten fasteners. |
| motor or support brackets. | D. Add water to normal level. |
| D. Low water level. | |
| E. Damaged or worn motor bear- | E * |
| ings. | F. * |
| F. Impeller rubbing inside case. | |
| G. Debris inside pump. | G. * |
|
|
|
6. Water leakage at pump shaft | A. Worn or damaged pump seal. | A. * |
(rotating connection between |
|
|
pump and motor). |
|
|
7. Motor will not start. | A. Power OFF. |
| B. House circuit breaker tripped or |
| in OFF position. |
| C. GFCI tripped. |
| D. Subnormal voltage. |
| E. Improper or defective wiring. |
| F. Locked shaft or impeller. |
| G. Motor windings burned out. |
| H. Defective starting switch inside |
| motor. |
A.Turn ON power at service panel.
B.Reset circuit breaker.
C.Reset GFCI.
D.Call an electrician or your power company.
E.*
F.*
G.*
H.*
8. | Motor stops. | A. | Motor overload condition. | A. Let cool for one hour. Motor |
|
|
|
| overload will reset; if problem |
|
| B. | Inadequate supply wiring. | persists, see *Note. |
|
|
|
| B. Consult electrician to correct |
|
| A. Power OFF. | wiring to unit. | |
|
| B. Switch is OFF. | A. Turn power ON at service panel. | |
9. | Air blower does not operate. | C. House circuit breaker tripped, no | ||
|
|
| power to system. | B. Press blower button. |
|
| D. GFCI tripped. | C. Reset circuit breaker. | |
|
| E. Faulty motor. | D. Reset GFCI. | |
|
|
|
| |
|
|
|
| E. * |
*NOTE: The skills and tools necessary for the safe repair of this spa require the services of qualified service personnel. Contact your Jacuzzi Whirlpool Bath dealer.
www.clearcreekspas.com