Jacuzzi Whirlpool Spa Control Panel, Temperature Controls, Jets Control, Blower, Light, Operation

www.clearcreekspas.com

OPERATION

The spa will automatically begin to operate when electrical power is applied. There is no ON/OFF switch for the spa system.

The control system has been designed so that by connecting the spa to its properly grounded power source and pressing the mode button, the spa will function properly and safely at 100°F. When your spa is first actuated, the display will alternately flash ECON, the current spa temperature, and COOL until the spa water is less than 15°F cooler than the set temperature. During each filter cycle, the spa will heat to the set temperature.

Control Panel

The control panel is easy to use with fingertip control of all the spa©s functions. Control of temperature, jets, blower and spa light is readily accessible from within the spa.

MODE	LIQUID CRYSTAL	WARM
	DISPLAY

JETS BLOWER LIGHT COOL

Temperature Controls

The current temperature is constantly shown on the

display. Press either or once to display the set temperature. (The set temperature is designated by a triangle on the left side of the display.) Each time either button is pressed again, the set temperature will in- crease or decrease depending upon which button is pressed. After 3 seconds, the display will automatically show the current spa temperature. Press any button to reset the system in the rare instance of an overheat condition.

Jets Control

Press the button once to activate the low-

speed jet operation. Press the button again for the high- speed jet operation, and again to deactivate the jets. The low-speed jet operation will start automatically when the heater is turned on or when a filter cycle is activated. When a freeze condition is detected, high speed jets are automatically activated.

Whenever the low-speed is energized with this button, it will automatically turn off after 4 hours of operation. The high-speed automatically turns OFF after 30 minutes.

Blower

The button starts and stops the blower for aeration in the spa.

The blower will automatically turn OFF after 30 minutes of operation.

Light
The	button activates and deactivates the spa
light.

The spa light will automatically turn OFF after 4 hours of operation.

6