Controls and operation 2-13
Radio set up
This function enables the radio to be set to user operating preferences. By selecting SET UP and using the preset buttons, the owner or Jaguar Dealer can adjust certain radio functions.
When in SET UP, pressing the relevant preset button, as detailed below, will display the facility selected and its state. The state of that facility can be changed by pressing the preset button again.
To enter SET UP: Press Tape Eject and AM/FM buttons simultaneously.
The display will show SET UP. The following preferences can then be selected or changed in any order, within a 15 second period. After 15 seconds the display will clear and exit SET UP.
Preset 1 Press Preset 1 to enable or disable RBDS,
| depending upon RBDS availability in the user’s |
| country. |
Preset 2 On cassette tape models, this controls the | |
| Tape Clean reminder facility. To switch off this |
| reminder, press the Preset 2 button until |
| TAPE CLN OFF shows on the display. |
Preset 3 | Blank. |
Preset 4 | Blank. |
Preset 5 KEY OFF EJECT – On cassette tape models, | |
| this sets the cassette tape to automatically eject |
| when the ignition key is turned to 0. |
Preset 6 | Blank. |
Preset 7 | Blank. |
Preset 8 | Blank. |
Preset 9 | Blank. |
Preset 0 | During initial factory installation, this is used to set |
| the radio to the USA region. Regional settings |
| determine the correct frequency increments |
| required for seeking stations, automatic tuning etc. |
| Note: The regions are preset at the factory. |
| Should you require a regional change, consult your |
| Jaguar Dealer. |
