CV-A11
5. Pin Assignment
5.1.12-pin Multi-connector (DC-IN/VIDEO OUT, EXT.HD/VD IN)
Type:
Seen from rear. |
| Pin configuration is compatible with EIAJ standard | |||||
|
|
| Pin no. | Signal | Remarks | ||
|
|
| 1 | GND |
|
| |
|
|
| 2 | +12 V DC input |
|
| |
1 | 9 |
| 3 | GND |
|
| |
| 4 | Video output | Parallel with the BNC connector. | ||||
2 | 10 | 8 | |||||
5 | GND |
|
| ||||
|
|
|
| ||||
|
|
|
|
| |||
3 11 | 12 | 7 | 6 | HD input/HD output | *) | Ω | |
|
|
| SW2.1 on for 75 . SW1.1 on for HD out. | ||||
|
|
| 7 | VD input/VD output | *) | SW2.2 on for75 . SW1.2 on for VD out. | |
4 | 5 | 6 |
|
|
| Ω | |
|
| 8 | GND |
|
| ||
|
|
|
|
| |||
|
|
| 9 | Pixel clk/WEN output | *)JP2 short. CW=1 for pclk. CW=0 for WEN | ||
|
|
| 10 | WEN output | *) *2) GND if JP5 open and JP3 short | ||
|
|
| 11 | Trigger input | *) | +12V DC if JP1 short and JP4 open | |
|
|
| 12 | GND |
|
| |
Fig. 2. |
|
|
|
| |||
Plugs for cable:
5.2.6-pin Multi-connector (TRIGGER and RS232C)
Type:
Seen from rear. |
|
|
|
| |
|
| Pin no. | Signal | Remarks | |
|
| 1 | TXD out | ||
1 | 6 | 2 | RXD in | ||
2 | 5 | 3 | GND |
|
|
3 | 4 | 4 | GND |
|
|
|
| 5 | Trigger input | *) | Parallel with pin 11 on 12 pin con |
|
| 6 | EEN output | *) | *3). For WEN out refer to chapter 10.2. |
Fig. 3. 6-pin connector.
| Plugs for cable: |
Notes: |
|
*) | Alternative signals can be placed on these pins by switch or jumper settings or |
| |
| Configurations shown in Bold + italic is factory setting. |
*2) | WEN (Write Enable) pulse indicates the period of effective video signal output. It is usefull |
| for setting the timing with framegrabber. |
*3) | EEN (Exposure Enable) pulse indicates the duration of the shutter, and can be used for |
| controlling strobe illumination. |
| EEN will be low all the time in normal continous mode (TR=0), if the selected |
| exposure time is longer than the frame readout time. |
For schematic diagram of the input and output circuit alternative settings refer to 5.3.
- 4 -
