JBL CS 360 Xcite SETUP PROCEDURE via Remote Control Only, Description Of Each Setup Function

SETUP PROCEDURE (via Remote Control Only):

English

The CS360 System enters SETUP when you press and hold the MENU Button on the Remote Control for 3 seconds.

The Front Display now shows the word TEST blinking. Press the [<] or [>] Navigation Button F on the Remote to scroll through the options. If scrolling with the Right Navigation Button, the Display shows these (blinking) words in the following order:

TEST – LEVELS – UNITS – DISTNC – LIPSNC – DISPLY - ON VOL – NAME - AU ON - AU SRC - RESET? - And TEST again.

Select any of these functions for adjustment by pressing the SET Button 4 on the Remote. See below for explana- tion of each adjustment.

If you want to leave the SETUP Mode at any time, press the EXIT Button E on the Remote once or twice.

NOTE: If the unit is left in SETUP mode or its sub-menus for 60 seconds without any user commands, the unit leaves SETUP menu and returns to regular operation.

NOTE: In SETUP, when a selection has sub-selections (such as LEVELS having a sub-selection of Front Left, Cen- ter, Front Right, ……), this selection blinks to prompt you

to press SET to enter the next menu layer. If a menu item offers no further options (such as Front Left Speaker in the LEVELS menu), the indication does not blink.

DESCRIPTION OF EACH SETUP FUNCTION

To enter the SETUP menu, first press the MENU Button for two seconds. When the Display shows the word TEST blinking, either acknowledge with the SET Button to enter the TEST tone menu, or move forwards or back between the Setup options with the RIGHT ARROW or LEFT ARROW Buttons. The following explanations follow the Setup Functions as you see them if using the RIGHT ARROW to circulate through the menus.

TEST:

After pressing the SET Button, a pink noise test signal circulates between the three speakers and the subwoofer, (sound from the subwoofer only if SUBWFR is ON). While the test signal is heard from each speaker, the Display shows which one you are listening to, as well as the level. (FL for Front Left, C for Center, FR for Front Right, S for Subwoofer). Adjust the output level by pressing the Up or Down Navigation Buttons. Initial level for all speakers is shown as “0”, and may be increased to +10 or decreased to -10, except the subwoofer, which may be increased to +20. The noise is heard from each speaker for 5 seconds, and if no action or adjustment is done, it goes to the next speaker. You can circulate between the speakers quickly by pressing the RIGHT ARROW Button. The system stays in TEST mode until you press EXIT or SET. SET or first press of EXIT will take you to the next SETUP item (LEVELS). A second press of EXIT button will cause the system to leave the SETUP menu.

LEVELS:

Here you can adjust the level of each speaker while lis- tening to normal music or any other program material of your choice. (No test tone or pink noise is heard). Press SET when LEVELS blinks on the Display. The Display shows “FL 0” for Front Left Channel, standard level. Increase or decrease the Level with the Up and Down Navigation But- tons, and move through the four speakers with the Left and Right Navigation Buttons, adjusting each one accord- ing to taste. When you are done, press SET or EXIT to jump to the next SETUP item.

UNITS:

Units lets you select either meters or feet for setting speaker distances. This selection is relevant only if you want to adjust Distance (next point).

DISTNC:

Adjusts perceived speaker Distance from user by add- ing delay. Select each speaker in turn with the Left and Right Navigation Buttons and adjust the distance from

0.0meters to 9.0 meters to reflect the actual distance between yourself and each speaker. Press SET or EXIT to jump to the next item.

WWW.JBL.COM 11