Manuals / Jenn-Air / Computer Equipment / Modem

Jenn-Air 1892, 1300 manual Format Mode AT F, At F?Crlf

Models: 1300 1892

1 32

Download 32 pages 27.63 Kb

Page 13

4.5Format Mode (AT F)

This command turns the Forward Error Correction (FEC) mode on and off. The over-air format allows for higher speed operation, but with reduced Bit Error Rate (BER) performance with the FEC turned off, or lower speed, improved BER with the FEC turned on.

Figure 1 and the associated table give the timing information for both modes of operation.

The command is:
Format mode	AT F=n<CR><LF>
Where	n=0 mode with FEC
	n=1 high speed mode without FEC
Default:	n=1 (non-FEC mode)
Read:	AT F?<CR><LF>
Read Return:	n<CR><LF>
Example:	AT F=1<CR><LF>

Hermes Operator Note

Page 13 of 32

Image 13

Jenn-Air 1892, 1300 manual Format Mode AT F, At F?Crlf

Contents

Lattice House Baughurst Basingstoke UK RG26 5LP Specialist RF DesignsTel +44 0 118 981 Fax +44 0 118 981 Received Signal Strength Indication Rssi AT S156 Table Of ContentsHandshaking Operation During Transmit and Receive List of Tables List of FiguresIntroduction Connections & Indications RS232 ConnectorPin No Function RF Connector Power ConnectorFront Panel Indications Introduction Modem OperationRS232 Data Handling Data Transfer ModesReceive-to-Transmit Turnround Description Time msMAX Command Mode List of CommandsOkcrlf Errorcrlf Command SyntaxParity ATB1 Baud Rate AT B0AT F?CRLF Format Mode AT FOK Crlf Engineering Test Modes ATRXX, Dxxxcrlf Software Version Information AT Command Mode Guard Time AT S154ATI9CRLF Centre Radio Frequency AT S155Rssi Level Level at RF Input dBm ±2dB Data Quality AT S158 Radio Channel AT S157Squelch Level Level at RF Input Squelch AT S159Output Power for 1W G-MAX Output Power for 2W G-MAX Transmission Power AT S160Power Level Output Power DBm Tolerance Nominal Level NominalTest Message Period AT S162 Channel Step Size AT S161Preamble Period AT S165 Note engineering function only Over-Air Symbol Rate AT S163 Note engineering function onlyFrame Synch Tolerance AT S166 Note engineering function only Invert Symbol AT S167Squelch Delay AT S168 Radio Frequency AT &F Restore defaults AT &Y8Save parameters AT &W AT &WCRLFATT?CRLF Display parameters ATT?Do not enter unless you wish to carry out a code load Ppppppppppppppppppppppppppppppppppppppppppppppppppppp RS232 Port Parameters Hardware SpecificationParameter Max SXn50 Radio SpecificationsEnclosures Mechanical SpecificationFront View of Casting Operating conditions Vibration SpecificationsType Approvals EMC