Jenn-Air JGC8430, JGC8645 important safety instructions Using Your COOKTOP, Cooktop AT a Glance

USING YOUR COOKTOP, CONT.

COOKTOP AT A GLANCE

MODEL JGC8430

SEALED BURNERS

The sealed burners of your cooktop are secured to the cooktop and are not de- signed to be removed. Since the burners are sealed into the cooktop, boilovers or spills will not seep underneath the cooktop.

However, the burner heads should be cleaned after each use. The head portion of the burner is easily removed for cleaning. (See page 6 for cleaning directions.)

tions (JGC8645). The simmer burner offers a lower BTU flame for delicate sauces or melting chocolate.

* BTU ratings will vary when using LP gas.

BURNER GRATES

The grates must be properly positioned before cooking. Improper installation of the grates may result in chipping of the

1 2 3 4

1.Left rear surface burner (10,500 BTUs).

2.Left front surface burner (6,500 BTUs on Hi, 850 BTUs on Lo).

3.Right front surface burner (12,000 BTUs).

4.Right rear surface burner (9,100 BTUs).

MODEL JGC8645

HIGH PERFORMANCE

BURNER (12,000 BTUS*)

There is one high speed burner on your cooktop, located in the right front position. This burner offers higher speed cooking that can be used to quickly bring water to a boil and for large-quantity cooking.

cooktop.

Do not operate the burners without a pan on the grate. The grate’s porce- lain finish may chip without a pan to absorb the heat from the burner flame.

Although the burner grates are durable, they will gradually lose their shine and/or discolor, due to the high temperatures of the gas flame.

1 2 3 4 5 6

1.Left rear surface burner (10,500 BTUs).

2.Left front surface burner (9,100 BTUs).

3.Center rear surface burner (6,500 BTUs on Hi, 850 BTUs on Lo).

4.Center front surface burner (6,500 BTUs on Hi, 850 BTUs on Lo).

5.Right front surface burner (12,000 BTUs).

6.Right rear surface burner (9,100 BTUs).

To prevent the cooktop from discol- oring or staining:

•Clean cooktop after each use.

•Wipe acidic or sugary spills as soon as the cooktop has cooled as these spills may discolor the porcelain.

SIMMER BURNER

(850 BTUS*)

This burner is located in the left front position (JGC8430) or in the center posi-

NOTES:

•A properly adjusted burner with clean ports will light within a few seconds. If using natural gas, the flame will be blue with a deeper blue inner cone.

If the burner flame is yellow or is noisy, the air/gas mixture may be incorrect. Contact a service technician to adjust. (Adjustments are not covered by the warranty.)

With LP gas, some yellow tips on the flames are acceptable. This is normal and adjustment is not necessary.

•With some types of gas, you may hear a “popping” sound when the surface burner is turned off. This is a normal operating sound of the burner.

•To improve cooking efficiency and to prevent possible damage to the range or pan, the flame must be adjusted so it does not extend beyond the edge of the pan.

5