InstallationOf Appliance
Follow accompanying ducting instructions carefully.
This appliance is designed to always be vented outdoors,
The Countertop Cutout, Cabinet Front Cutout and Duct Opening should be prepared according to the illustration on pages 1 and 2.
Installthe Lower Control Panel in the bottom of the
Cabinet Cutout as shown using screws from Hardware pack. (Figure 1).
Tl_pVlmlLOWER_ PANEL
Figure 1 | L. I _=,,_l II | LF |
Position unit in the Countertop Cutout. Main Control Panel
should overlap top of Lower Control Panel as shown. (F{gure 2).
NOTE: For some cabinet styles, it may be necessary to reinforce the front of the cabinet by attaching a brace from front to rear inside the cabinet under the Burner Box.
Installductwork per ducting instructions provided. Duct openings in cabinet are shown in the drawing on page 1. Make electrical and gas connections as described below
in this section of the instructions.
The installationof this appliance must conformwith local codes or, in the absence of local codes, with the latest editionof the National FuelGas Code, ANSI Z.223.1 USA
The electrical supply required is
recommended, for convenience, this outlet be located in or current
the area shown in the shaded illustration. This appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local
codes, with the latest edition of the National Electrical Code ANSI/NFPA No. 70 USA or current CSA
STANDARD C22.1 Canadian Electrical Code part 1.
¢¢®e e,,-= ¢ ®
.EL | Servicing Cooktop |
| When servicing cooktop it is necessary to remove the |
F_gure2 | main top, prior to removing the control panel. |
