Jenn-Air JGD8348BDP dimensions Conversion To LP Gas, Control Settings, setting, Illustration E

Conversion To LP Gas

This appliance is shipped from the factory equipped for use with Natural Gas. To convertit from NaturalGas for use with LP Gas, performsteps 1 through4.

1.Remove Natural Gas orificehoods.Installcolor coded

orificehoodssupplied.Located in a packattachedto the outer plenumarea of this appliance,

(See Illustration"E", below,and LP Gas Conversion instructionspage 8).

2._nvertcap in convertiblepressureregulator(if so equipped)locatedat entranceto gas manifold,

3. Adjustair shutterson individualburnersfor proper flame appearance.

4. Adjustlow flame settingat each burnerby turning adjustmentscrew in center ofvalve stem.

To make these conversionsadjustmentsfollowthe instructionsand illustrations("A" through"E", pages 5-7).

Apply a non-corrosiveleak detectionfluid to all joints and fittingsin the gas connectionbetweenthe supply lineshut-offvalve and the range. Includegas fitting and jointsin the range if connectionswere disturbed during installation.Check for leaks! Bubblesappearing aroundfittingsand connectionswillindicatea leak, If a leak appears,turn off supplylinegas shut-offvalve, tightenconnections,turn on the supplyline gas shut off valve, and retestfor leaks. Never test for gas leaks with an openflame.

This appliance is shipped from the factory with orifice hoods drilled for use with Natural Gas. To convert from

Natural Gas to LP, apply a 112"open-end wrench to hex section of orifice hood. Turn counterclockwise to remove.

Save the Natural Gas orifice hoods just removed from this appliance for future use. Install color coded orificehoods supplied. (See LP Gas Conversion instructions above and page 8). Turn clockwise to install. Hold dimension specified in illustration "E".

1/2" OPEN END _	J
WRENCH

			CLOCKWISE
TURN	•		TO TIGHTEN
	1	_	TURN
COUNTERCLOCKWISE
TO REMOVE			ORIFICE HOOD

Control Settings

The size and type of cookwareand the amountand type of foodbeing cookedwill influencethe settingneededfor bestcookingresults.The settingindicatedshouldserve as

a guidewhile you become familiarwith your cooktop.

Use the HI flame settingto quicklybringfoodsto a boilor to

begina cookingoperation.Then reduce to a lower settingto continuecooking.Never lease foodunattendedover a HI flame

setting.

Med settingis used to continuea cookingoperation.Food will not cook any fasterwhen a HI flame settingis used than that needed to maintaina gentleboil. Remember,water boilsat the same temperaturewhether boiling gentlyor vigorously.

Use LO settingto keep food at servingtemperatureswithout further cookingYou may find that some cookingmay take place if the cookwareis covered.

Illustration "E"