Jenn-Air SCE30500, SVE47100 Plan The Duct Run, Duct Length Chart, Install The Duct Hardware

PLAN THE DUCT RUN

1.Make a sketch of the total system. Identify the type of each fitting and the length of straight pipe.

2.Enter your run into the 'DuctLength Chart'in the next section.

Example I					Example 2
__	_.5"to 6" Transition				to 6" Transition
		2' of 6"		ound
					Elbow
					2'of 6" Round
		\	.6' Elbow		6" Elbow
	'	\			6" Round
				4' of 6" Round	)_"
		6" Elbow			;"Elbow
					4'of 6" Round
.	6 of 6 Round

6" WallCap

31/4" X10"Transition

10' of 3¼"x 10"Straig C,..,.

DUCT LENGTH CHART

1. Elbows, wall caps and other fittings are shown in the table on page length. Each fitting value must be added to the amount of straight overal! straight duct equivalent length.

2. Using the examples above:

3 with their equivalent straight duct duct length used, to determine the

ExampleI	DuctFitting No.ofFittings		TotalEquivalent	Example2
				DuctFitting		No.ofFittings	TotalEquivalent
	Equivalent		Length-Fittings	Equivalent			Length-Fittings
	Length			Length
5"to6"Transition	1	1	1	5"to6"Transition	1	1	1
6"Straight	"f	2+4+6= 12	12	6"Straight	t	2+4+6+4= 16	"t6
6" Elbow	5	2	10	6"Elbow	5	3	15
6"WallCap	0	1	0	6"to31/'x10":	1	1	1
				Transition
Total			23	31/4x10, ,Straight	1	10	10
				31/4"x 10"WallCap	0	1	0
				Total			43

INSTALL THE DUCT HARDWARE

1. Using good quality ducting material, install per these instructions. Follow the General Considerations page 1, Do'sand Don'ts box on page 4, and Grill-Range Installation Instructions. A few minutes an£1 pennies spent now will pay long term dividends for the life of the range.

2