Jenn-Air SVE47100 CheckOperation, Ec K, Insta ll AccessPanel and LowerAdjustable Panel Figure

19. Level Range (Figure 19) --IL ll

•Free-Standing.Adjustthelevelerfeet to levelrangewiththe countertop.

•Slide.ln.Adjustthelevelerfeettotakesomeoftheweightoffefthecountertop.

•Unit must be level for optimum baking performance. Check levelness inside oven using a level that is placed on oven rack.

•Fornon-downdraftunitsgo to step 22.

	(Figure 19)
20. Connect Blower Electrical (Downdraft Units Only) (Figure 20)	,ow_,co,o
	BLOWER	]lJ
• Connectthe blower power cord on the range to the blower (see illustration.)	_]__	iolli i I

21.Install Flex Duct (Downdraft Units Only) (Figure 21)

•Attach the flex duct to the blower and range (see illustration.) Using a

	screwdriver,securelytighten duct clamp at each connection.		(Figure 20)
22. CheckOperation (Figure22)		_! _,f		_k,_
•	Unpackand install grill element in one side and optional cookingcartridge in
	otherside.
•	Be sure to remove all packaging materialsfrom unit priorto applying power.
•	Switchthe electricalcircuit breakerto the ON position.
•	ConsultUse & Care Manualfor operation.			(Figure21)
•	Checkrangetop elements.Fancomeson automaticallywhengrill is turnedon,	C.ECK	.EAT pOWOE,
•	ovenCheck.C°°kingcheckventCartridgefanoesnot, energize fan automatically.	__A,,
	there are no air leaks. Verify properairflowwith airflowcard.			ROLS
•	With vent fan on, check all vent duct connectionsto the outside to make sure	__"
23. Install Lower Left and Right Side Toe Plates (Figure 23)			(Figure 22)
•	Pull protectivebackingfrom tape.	..,,,	_	_.._--_ :

•Set Sideplate on floor guide plate between cabinet and range until plate is positioned over the side trim. Press plate againstside trim on range to insure tape has bonded.

•For Non-Downdraftunits,finish your installationby replacingthe drawer.

24. Install AccessPanel and LowerAdjustable Panel (Figure 24) (Figure 23)

•After checking for air leaks at duct connections,install the lower range door.

•Measurethedistancebetweenthe lowerpanelclipand thefloor.Dimension"A".

•Cut covemolding (providedon some units- see Note2)to this Dimension"A".

•Insertcove molding (or otherselected material) into lower panel clip.

NOTE: 1) It will be easierto attachthe cove molding if the access door is removedfrom the range.

2)To matchyour installation,variouscolors of cove moldingmaybe

	purchasedfrom any building supplystore,	i _.,_S::._ '
25. Install Jars (Downdraft Units Only) (Figure 25)
•	Openaccess panel.	(Figure24)
•	Placedrain jars intotheir holderslocated behindthe front legs of the range.

NOTE:On units with one side grilling, only one drain jar is supplied.

(Figure25)

6