Jenn-Air SCE30600, SVE47100, SCE30500 dimensions UnpackRange Figure

1. UnpackRange (Figure 1)

•Cut and remove shippingcarton.

•Removelower rangepanelor drawer,and place outofwork area.

•Removeblower package (if you have not already done so.) (Downdraft ModelsOnly.)

•LocateDuctingInstructionsheet. (DowndraftModelsOnly.)

NOTE:Please read through entire installation instructions and ducting	1
instructions priorto beginninginstallation.

2. Select Range Location(Figure 2)

•Carefullyselectthe rangelocation,keepingin mindthe following:

A. Over-rangecabinetsarenotrecommended.However,ifnecessarys,ee

B.Makesure electricalpower can be provided.(See #13.)

C.For downdraftranges planthe range ductingsystem. (Per#'s9-12 and ductinginstructions.)

D.Make sure there is adequatespace. (See#'s4, 5, 6, and 7.)

E. island or peninsularinstallationswith 24" deep base cabinet must use

(Figure 1)

_- _ _"

', --"q-',_-- '

.________L .._--.

L_'N.J OVERNoTCOMMCABINETDEDRANG[

_lscr,)1.24(s_ ,)

rear toe space is desired, use 27" or deeper base cabinets.					25" MIN.
NOTE:ThisrangecomplieswithUL requirementsfor "1"clearancefrom the					_63.¢o,,)
rangeto adjacentverticalsidewallsand7/8" fromrearverticalwall.					t ..
flush back (no rear	space)	to avoid	interference, lfa	I,r_	.' (
Abnormalsurfatoec unitoperatcabinetson(highheatrangednoutensils)could

resultinpossiblescorching,ofverticawal ilsandposea potentiaflire

hazard. Therefore, a _, (15.24 cm) minimum spacing is(Figure2) recommended.On Downdraftmodels6" spacingis requiredfor properventilation.(See illustration.)

SLIDE-IN

3.Type of Installation (Free-Standing/Slide-In)(Figure 3)

•Will range be free-standing?(Rangesettingonfloor.)If so, go to #7.

•Will rangebe slide-in?(Rangetop restson countertop.)If so, go to #4.

•Theseapplianceshavebeendesignedinaccordaneewiththerequirements of varioussafetyagenciesand complywiththe maximumallowablewood cabinet temperatures of 194°F. If these appliances are installed with cabinetsthat havea lowerworkingtemperaturethan194°F,discoloration, delaminationor meltingmay occur.

NOTE:Slide-incutoutdoesnotallowfor use ofbacksplashor sidepanels.

If eitherare desired,usethe free-standingcutoutand instruction. (Figure 3)

•Moststandardcountersare 25" (63.50cm) deep,36" (91.44cm) high,and extend 1" (2.54cm) over the cabinet front.

•Measurethe countertop and overhange.

4. Measurefor Slide-InCutout (Figure 4) _!iii

(Figure4)