Jenn-Air SCE30600, SVE47100, SCE30500 dimensions Jenn-Air, Step, Right Side, Left Side, Spacer

Step 4
Attachthe blowerhousingto thefloor withthe outlettoward thedirection	Right Side	Left Side	I
of venting and the inlettoward the front of the cabinets. (See Figures 2	Venting	Venting
and 3 for specific location.) in addition,for left side venting, a spacer			I
{erthemountingbracketflanges ofthe blowerassembly. (SeeFigure
Step 5	__
_,_proximately1-1/2" thick x 9" long (3.81cm x 22.86 cm)is required
Removethe inside wire and theoutsidestringfrom thefirst 1-1/2inches		Spacer/
(3.81cm) of one end of the 5" (12.7cm) flex duct (P/N702935.)Stretch
this end of the flex duct over the end of the 5" to 3-1/4" x 10" (12.7cm	(Figure 5)
to 8.26 cm x 25.4 cm) transitionand secure it with a hose clamp (P/N	ViewfromAir Inlet Side of Blower
702331.)

Step 6

Whenthe range is placedinto position,feed the open end of the 5" (12.7cm)flex ductthroughthe hole in the cabinet side wall and throughthe side of the range, attach it to the outlet of the blower housingand secure it with a hose clamp (P/N 702331.)

Thetransitionshouldthen beattachedtothe 3-1/4"x 10" (8.26cmx 25.4cm) ductingin thecabinettoespacethroughthe cabinet floor cutout.

Step 7

Installthe 6" (_5.24cm) elbowto the inlet of the btowerhousing and secureit with ducttape. The open end of the elbow should be pointedto the left. Attach the 6" (15.24cm) flex duct (provided with the range)to the elbowand to the range. Secure it with 2 hose clamps (P/N 702331.) See Step 21 of the installationinstructions.

NOTE: Forrightsideventing,the 6" (15.24cm)diameterflex ductmay becutinhalfand useone sectioninsteadof thefull length. "- make it easier to assemble.

'JENN-AIR

403WESTFOURTSHTREENTORT, •HNEWTOIAN,50208