3.Pull the bottom forward and then pull down to remove the lower access panel.
4.Remove dirt and lint from the condenser fins and the unit compartment with a brush attachment on a vacuum cleaner.
5.Replace the lower access panel using the four screws.
6.Plug in ice maker or reconnect power.
Interior Components
1.Unplug ice maker or disconnect power.
2.Open the storage bin door and remove any ice that is in the bin.
3.Remove the drain cap from the water pan and drain thoroughly. Replace the drain cap securely on the water pan. If the drain cap is loose, water will empty from the water pan, and you will have either thin ice or no ice.
4.Remove the two screws that hold the cutter grid cover in place and remove the cutter grid cover.
5.Unplug the wiring harness from the left side of the cutter grid.
A
B
A. Cutter grid cover
B.Screws
6.Unplug the ice level sensor from the right side of the cutter grid. Pull the ice level sensor down and forward away from the cutter grid.
7.Remove the
NOTE: Make sure the plastic spacer from the
D
A |
| |
B | E | |
C | ||
F | ||
| ||
A. Cutter grid harness | D. Ice level sensor harness | |
B. Screw | E. Plastic spacer | |
C. Cutter grid | F. Screw |
8.Remove the two thumb screws that hold the water pan in place. Push down with one hand on the front of the pan while pulling forward on the bottom back side.
B | A |
B |
C
A. Water pan
B. Water pan thumb screws
C. Drain cap
9.Remove, clean and replace the ice scoop and ice scoop holder.
■After removing the ice scoop, remove the holder by removing the two thumb screws.
■Wash the ice scoop holder along with the other interior components using the following instructions.
■Replace the ice scoop holder by replacing the thumb screws.
A
B
A. Thumb screw
B. Ice scoop holder
10.Wash the interior components (cutter grid, exterior of hoses, and water pan) and the storage bin, door gasket, ice scoop, and ice scoop holder with mild soap or detergent and warm water. Rinse in clean water. Then clean the same parts with a solution of 1 tbs (15 mL) of household bleach in 1 gal. (3.8 L) warm water. Rinse again thoroughly in clean water.
NOTE: Do not remove hoses. Do not wash plastic parts in dishwasher. They cannot withstand temperatures above 145°F (63°C).
11.Replace water pan by pushing back on the bottom with one hand while pushing up and back on the top. Secure the water pan by replacing both screws.
12.Check the following:
■Drain cap from the water pan is securely in place. If the drain cap is loose, water will empty from the water pan, and you will have either thin ice or no ice.
■Hose from water pan is inserted into storage bin drain opening.
13.Slide the cutter grid back into place and secure it by replacing the
14.Replace the cutter grid cover and the two screws.
15.Plug in ice maker or reconnect power.
12
