RANGE HOOD CARE
Range Hood Lamps | Cleaning |
Replacing a Halogen Lamp
Turn off the range hood and allow the halogen lamp to cool. To avoid damage or decreasing the life of the new bulb, do not touch bulb with bare fingers. Replace bulb, using tissue or wearing cotton gloves to handle bulb.
If new lamps do not operate, make sure the lamps are inserted correctly before calling service.
1.Disconnect power.
2.Push up on the lens and turn it counterclockwise.
3.Remove the bulb and replace it with a
4.Repeat steps 2 and 3 for the other bulb if needed.
5.Reconnect power.
Replacing the Infrared Heat Lamps
Turn off the range hood and allow the infrared heat lamp to cool. To avoid damage or decreasing the life of the new lamp, do not touch lamp with bare fingers. Replace lamp, using tissue or wearing cotton gloves to handle lamp.
If new lamps do not operate, make sure the lamps are inserted correctly before calling service.
1.Disconnect power.
2.Twist lamp counterclockwise to remove.
3.Remove the lamp and replace it with a
4.Repeat steps 2 and 3 for the other lamp if needed.
5.Reconnect power.
Exterior surfaces:
To avoid damage to the exterior surface, do not use steel wool or
Always wipe dry to avoid water marks.
■Stainless Steel Cleaner and Polish.
■Mild liquid detergent and water.
■Wipe with damp soft cloth or nonabrasive sponge, then rinse with clean water and wipe dry.
Metal Filters and Drip Trays:
Use 2 hands to remove filters. Grasp filter handles, pull toward the front of range hood and pull down on the rear handle to remove. Repeat for each filter.
A 
A. Grease filter
Remove grease drip tray.
A
A. Drip tray
Wash metal filters and grease trays as needed in dishwasher or hot detergent solution to clean.
Replace grease drip tray.
Reinstall filters, grasp filter handles and place front edge of filter into the hood. Push up on the back handle and set rear of filter into the drip tray to secure. Repeat for each filter.
A 
A. Grease filter
Thermal Protector
The range hood is equipped with a thermal protector to avoid overheating conditions. If the range hood shuts off while in use, move the blower switch to the “Off” position. Wait approximately 60 minutes, then move the blower switch to the first position to restart the range hood.
12
