Jenn-Air W10379137A manual Remove Trim Pieces, Install Door Panels

■Use the Standard Grille brackets for a Standard Installation with a flush grille, as shown.

A

B

A. Top grille brackets

B. Grille trim piece

2.Using round head screws (provided with refrigerator), attach the grille trim piece to the bottom of the grill panel.

NOTE: The grille trim is preinstalled on the panel kits.

Remove Trim Pieces

1.Remove all tape and door bracing from the refrigerator and freezer doors.

2.Open the refrigerator and freezer doors.

3.Remove the hinge cover trim pieces from the top and bottom of the door to expose the holes in the hinges.

NOTES:

■It is not necessary to remove the hinge side trims as they will not interfere with the installation

■Leave the freezer drawer trims in place for installation.

4.Remove the handle side trims. See the following graphic.

A

B

A

Install Door Panels

NOTE: French door models, first open the door opposite from the one to which you are installing the door panel.

1.Lower the panel bracket onto the door adjustment pins at the top of the door.

A

B

C
A. Door panel	C. Adjustment pins
B. Panel top bracket

2.Locate the studs on the back of the door panel. Slide the studs, top stud first followed by the bottom stud, into the “J” pockets in the front of the door.

NOTE: It is the washer in the stud, not the head of the stud, that is inserted in the “J” pocket.

3.Slide the door panel down into the “J” pocket.

4.French door models, repeat steps 1 through 3 to install the second door panel.

5.Using a slotted hex head screw (provided with refrigerator), attach the mounting bracket (factory installed), located at the bottom of the refrigerator door(s), to the respective door panel(s). Do not fully tighten the screw.

A. Hinge cover pieces	A	B
B. Handle-side door trim		A. Bottom hinge
		B. Mounting bracket

24