■Replace the ice scoop holder by replacing the screws.
A 
B
A. Screws
12.To replace the water pan, set the water pan inside the ice bin. Hook up the water pan pump. Snap the pump bracket back onto the water pan and place back into position. Secure the water pan by replacing the mounting screw.
13.Check the following:
■Drain cap from the water pan is securely in place. If the drain cap is loose, water will empty from the water pan, and you will have either thin ice or no ice.
■Hose from water pan is inserted into storage bin drain opening.
14.Slide the cutter grid back into place and secure it by replacing the
B. Ice scoop holder
11.Wash the interior components (cutter grid, exterior of hoses, and water pan) and the storage bin, door gasket, ice scoop, and ice scoop holder with mild soap or detergent and warm water. Rinse in clean water. Then clean the same parts with a solution of 1 tbs (15 mL) of household bleach in 1 gal. (3.8 L) warm water. Rinse again thoroughly in clean water.
NOTE: Do not remove hoses. Do not wash plastic parts in dishwasher. They cannot withstand temperatures above 145°F (63°C).
15.Replace the cutter grid cover.
16.Gently wipe the control panel with a soft, clean dishcloth using warm water and a mild liquid dish detergent.
17.Plug in ice maker or reconnect power.
18.After cleaning, make sure that all controls are set properly and that no control indicators are flashing.
Vacation and Moving Care
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
To Shut Down the Ice Maker:
1.Unplug ice maker or disconnect power.
2.Remove all ice from storage bin.
3.Shut off the water supply.
4.Remove the 2 screws in the lower access panel and the
2 screws from the base grille area of the front panel support. Pull forward to remove the lower access panel.
5.Disconnect the inlet and outlet lines to water valve. Allow these lines to drain and then reconnect to the valve.
6.Replace lower access panel and screws.
7.Drain water from water pan by removing the drain cap.
8.If the room temperature will drop below 32°F (0°C), water must be removed from the drain line.
For Ice Makers with a Drain Pump Installed:
■Plug in ice maker or reconnect power.
■Turn ice maker off and remove all remaining ice from ice bin.
■Pour 1 qt (0.95 L) of water into the ice bin near the drain and let the ice maker stand for approximately 5 minutes. This will allow the water in the bin to drain into the drain pump so that the pump will remove the remaining water from the ice bin and the drain pump.
■Unplug ice maker or disconnect power.
9.Before using again, clean the ice maker and storage bin.
10.Plug into a grounded 3 prong outlet.
NOTE: All components of the ice maker are permanently lubricated at the factory. They should not require any additional oiling throughout the normal life of the machine.
16
