Condenser
A Dirty or Clogged Condenser
■Obstructs proper airflow.
■Reduces ice making capacity.
■Causes higher than recommended operating temperatures which may lead to component failure.
WARNING
Electrical Shock Hazard
Disconnect power before cleaning.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1.Unplug ice maker or disconnect power.
2.Remove the 2 screws in the lower access panel and the
2 screws from the base grille area of the front panel support.
3.Pull the bottom forward and then pull down to remove the lower access panel.
4.Remove dirt and lint from the condenser fins and the unit compartment with a brush attachment on a vacuum cleaner.
A
A. Condenser fins
5.Replace the lower access panel using the 4 screws.
6.Plug in ice maker or reconnect power.
Interior Components
1.Unplug ice maker or disconnect power.
2.Open the storage bin door and remove any ice that is in the bin.
3.Remove the drain cap from the water pan and drain thoroughly. Replace the drain cap securely on the water pan. If the drain cap is loose, water will empty from the water pan, and you will have either thin ice or no ice.
4.Pull out on the bottom of the cutter grid cover until the snaps release to remove.
5.Unplug the wiring harness from the left side of the cutter grid.
A
A. Cutter grid cover
6.Unplug the ice level sensor from the right side of the cutter grid. Pull the ice level sensor down and forward away from the cutter grid.
7.Remove the
NOTE: Make sure the plastic spacer from the
| D | |
A |
| |
B | E | |
C | ||
F | ||
|
A. Cutter grid harness | D. Ice level sensor harness |
B. Screw | E. Plastic spacer |
C. Cutter grid | F. Screw |
8.Remove the mounting screw that holds the water pan in place. Pull out on the front of the water pan.
9.Disconnect the pump bracket from the water pan and unplug the water pan drain pump.
A |
| |
B | D | |
C | ||
|
A. Water pan | C. Drain cap |
B. Water pan screw | D. Drain pump cover |
10.Remove, clean and replace the ice scoop and ice scoop holder.
NOTE: On some models, the ice scoop holder is located in the upper left of the unit, and on other models, the ice scoop holder is located in the lower left of the unit.
■After removing the ice scoop, remove the holder by removing the 2 screws.
■Wash the ice scoop holder along with the other interior components using the following instructions.
15
