Accessories
To order accessories, in the U.S.A., visit our web site www.jennair.com/accessories or call
In Canada, visit our web site www.whirlpoolparts.ca or call
Water Filter | affresh®* Stainless Steel Wipes |
Order Part Number F2WC9I1or ICE2 | In U.S.A., order Part Number W10355049 |
Cleaner | In Canada, order Part Number W10355049B |
Order Part Number 4396808 | affresh®* Kitchen & Appliance Cleaner |
affresh®* Stainless Steel Cleaner | In U.S.A., order Part Number W10355010 |
In U.S.A., order Part Number W10355016 | In Canada, order Part Number W10355010B |
In Canada, order Part Number W10355016B |
|
*®affresh is a trademark of Whirlpool, U.S.A. |
|
PERFORMANCE DATA SHEET
Ice Maker Water Filtration System
Model P6GEG2KL, P6KG2KL, P6WG2KL Capacity 2000 Gallons (7571 Liters)
System tested and certified by NSF
International against NSF/ANSI
Standard 42 for the reduction of
Chlorine Taste and Odor.
This system has been tested according to NSF/ANSI Standards 42 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42.
Substance Reduction | NSF Reduction | Average | Influent Challenge | Maximum | Average | Minimum % | Average % |
Aesthetic Effects | Requirements | Influent | Concentration | Effluent | Effluent | Reduction | Reduction |
|
|
|
|
|
|
|
|
Chlorine Taste/Odor | 50% reduction | 1.9727 mg/L | 2.0 mg/L ± 10% | 0.71 mg/L | 0.7788 mg/L | 70.2 | 72.81 |
Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.50 gpm (1.89 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 2000 gallons (7571 liters).
■It is essential that operational, maintenance, and filter replacement requirements be carried out for the product to perform as advertised.
■Use replacement filter P6RFWG2K, P6RFGEG2K, P6RFKG2K, Part Number ICE2.
Style 1 – When the water filter status display changes from “GOOD” to “ORDER,” order a new filter. When the filter indicator reads “REPLACE,” it is recommended that you replace the filter.
Style 2 – Press FILTER to check the status of your water filter. If the filter indicator light is yellow and the words “ORDER FILTER” appear on the display screen, order a new filter. If the filter indicator light is red, it is recommended that you replace the filter.
■These contaminants are not necessarily in your water supply. While testing was performed under standard laboratory conditions, actual performance may vary.
■The product is for cold water use only.
■Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
■Refer to the “Warranty” section for the Manufacturer’s name, address and telephone number.
■Refer to the “Warranty” section for the Manufacturer’s limited warranty.
Application Guidelines/Water Supply Parameters
Water Supply | City or Well |
Water Pressure | 30 - 120 psi (207 - 827 kPa) |
Water Temperature | 33°- 100°F (0.6° - 37.8°C) |
Service Flow Rate | 0.50 gpm (1.89 Lpm) @ 60 psi |
® NSF is a registered trademark of NSF International.
20