~
Preparation
Tools and Supplies
The following tools and supplies are needed to install the radio.
Torx type, flathead and Philips screwdrivers Wire cutters and strippers
Tools to remove existing radio (screwdriver, socket wrench set or other tools)
Electrical tape Crimping tool
Volt meter/test light Crimp connections
18 gauge wire for power connections
SPEAKER REQUIREMENTS: Only connect speakers rated in the load impedance of 4 ohms. Speakers with a load impedance less than 4 ohms could damage the unit.
Disconnecting the Battery
To prevent a short circuit, be sure to turn off the ignition and remove the negative
Removing the Transport Screws
Before installing the radio, you must remove the transport screws from the top of the radio. The transport screws are clearly marked.
Remove before installation.
HD5212
NOTE: If the HD5212 is to be installed in a car equipped with an on- board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation to avoid causing a short circuit.
WARNING! Only connect the unit to a
WARNING! Never install this unit where operation and viewing could interfere with safe driving conditions.
WARNING! Never disassemble or adjust the unit.
WARNING! Avoid installing the unit where it will be subject to excessive temperature, such as from direct sunlight or hot air from the heater, or where it will be subject to dust, dirt or excessive vibration.
WARNING! To prevent injury from shock or fire, never expose this unit to moisture or water.
WARNING! Never use irregular discs.
WARNING! Using an improper fuse may cause damage to the unit and result in a fire.
2
