Troubleshooting

Problem

Cause

Corrective Action

No power.

Vehicle ignition switch is not

If the power supply is connected to

 

on.

the vehicle accessory circuits but

 

 

the engine is not moving, switch the

 

 

ignition key to “ACC”.

 

 

 

 

The fuse is blown.

Replace the fuse.

No sound.

Volume turned down too low.

Adjust volume until sound is heard.

 

Wiring not connected properly.

Check wiring connections.

Radio does not work

Antenna cable not connected.

Insert antenna cable firmly.

JHD1000

Specifications

General

Power Supply Requirements . . . . . . . . . . . . . . . . . . . . . . . . . DC 12 Volts, Negative Ground Chassis Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 178 (W) x 178 (D) x 50 (H) Loading Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 -8 ohms per channel Tone Controls . . . . . . . . . . . . . . . . . . . Bass (at 100 Hz), ±10 dB; Treble (at 10 kHz), ±10 dB Current Drain . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Ampere (max.)

FM Tuner

Tuning range. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .87.5-108.0 FM mono sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.5uV Stereo separation @ 1 kHz. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >25dB

AM Tuner

Tuning range. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .522-1710

Amplifier

Total system power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 120W (30W x 4)

Specifications subject to change without notice.

www.asaelectronics.com

© 2006 ASA Electronics Corporation

v.040506

6

Page 6
Image 6
Jensen owner manual Troubleshooting, JHD1000 Specifications, ASA Electronics Corporation 040506