Jensen MP8610BT owner manual Preparation

Preparation

Getting Started

It’s a good idea to read all of the instructions before beginning the installation.

Tools and Supplies

The following tools and supplies are needed to install the radio.

•Torx type, flat-head and Philips screwdrivers

•Wire cutters and strippers

•Tools to remove existing radio (screwdriver, socket wrench set or other tools)

•Electrical tape

•Crimping tool

•Volt meter/test light

•Crimp connections

•18 gauge wire for power connections

•16–18 gauge speaker wire

NOTE: Only connect speakers rated in the load impedance of 4 ohms. Speakers with a load impedance less than 4 ohms could damage the unit.

Disconnect Battery

			MP8610BT
Remove Radio from Sleeve
Remueva el Radio de la Manga
Enlever la radio du manchon
AS/PS	MP8610BT
		MOSFET 72	W A TTS
	MP3/WMA	RECEIVER
			P
			TM
			/
			PHONE

Before you begin, always disconnect the battery negative terminal.

Remove Radio from Sleeve

Lift latches on both sides of sleeve to remove half-sleeve from radio.

Install Half-Sleeve

1.Install adapter and dash kit if necessary (optional).

2.Install half-sleeve into adapter or dashboard.

3.Push tabs out to secure half-sleeve in the radio opening.

4.Install support strap to stabilize unit.

Install Half-Sleeve

Instalación de la Camisa

Installation du demi-manchon

4

3

1

2

Connect Wires

Conecte los cables

Raccordement des fils

Jensen Connector

1

2

6